CDKCDK9676 CDKCDK9676

26-02-2021
Engineering

contestada

stimate the force required in extruding 70-30 brass at 700C, if the billet diameter is 125 mm and the extrusion ratio is 20

Relax

Respuesta :

jadencajina jadencajina

26-02-2021

U have to find the bill it into the internet in order for me to get the answer. Also u have to make it change into the call.

Answer Link

Otras preguntas

If Earth were twice as far from the sun, the force of gravity attracting the Earth to the Sun would bea. twice as strongb. half as strongc. one-quarter as stron

If the area of the trapezoid below is 98 square units,what is the value of x?Plz help!

P waves move through the crust at a speed of about 6.5 km/s. How far will the P wave move in five seconds?

what is the average speed of a cheetah that runs 70m in 2.5 seconds?

A nucleus undergoes radioactive decay, emitting a gamma ray. Which of the following statements is true?A). A nuclear proton changes into a neutron-electron pair

Mr. Heng must maintain a minimum daily balance of $500 in his checking account to avoid a monthly service fee. Write an inequality to represent the possible bal

water tank a has a capacity of 550 gallons and is 66 percent full. water tank b is 53 percent full. the ratio of the capacity of tank a to tank b is 11:15A: how

If a rectangle with a perimeter of 48 inches is equal in area to a right triangle with legs of 12 inches and 24 inches, what is the rectangle’s diagonal?

Sandy decides to try golfing. She stands on the outer edge of a circular putting green. In the very centre if this putting green is the hole; it is 8m away from

If sin α = 12/13 , and cosα = 5/13 , then tanα =? It would be great if you could add a few words of explanation